Fault codes AGAIN
Posted 05 September 2018 - 12:47 PM
1. P0020 A camshaft position actuator circuit. Open bank 2
2.P0095 intake air tempreture sensor 2 circuit.
MIL light is on also. Car runs fine..
As usual. Any input is appreciated..
Posted 18 September 2018 - 08:24 PM
try doing dropping of the battery and doing hard reset on ecu, then clear codes. Some times this pop up for no reason. The pic can be a bugger for fault codes as some many items use duel circuits which throws weird codes. Anyone else got thoughts on these?
Posted 20 September 2018 - 11:13 PM
Oops, there's an echo on the site. Disconnect wait for some time then reconnect.
Arctic Steel - of course!
Posted 26 September 2018 - 09:06 AM
What do you mean hard reset... do you mean disconnect the battery and then reset the bsi?
Yes, as others have said, disconnect the battery. But do follow the correct procedure as described in topic no. 14 of the FAQ. I.E. everything switched off, all doors closed, remove key from ignition and wait 3 minutes before disconnecting. Note that there's no need to perform gymnastic contortions through an open window to reach the battery, either disconnect the outgoing lead from the big black terminal block under the bonnet (but take care to avoid shorting out to any other metal parts in the process) or sit in the back seat and disconnect the battery earth terminal. When once the battery is disconnected you can open doors as much as you like but make sure they're all shut again before reconnecting.
After reconnecting the battery wait 10 seconds with all doors still shut, switch on the headlights and then insert the key and start the engine.
- thehytheman likes this
Xsara Picasso (58) 1.6i 16V Desire, Iron Grey